| WHY CHOOSING A RW9 :
Advantages of the design :
- The 3 link pins are locked in swing to avoid wear on yokes.
- 2 bearings of the same diameter in headstock to increase strength.
- With 50 cm range, the independant hydraulic adjustment on the first furrow (”on the go”) allows :
* to get the plough outside line in case of ditches or hedges,
* the use of several tractors with different width without mechanical adjustment,
* the ability to set the first body in the furrow in case of hard soil conditions.
- Improved balance of the efforts on the bodies as the pivot point is located in the middle of the share and safety devices,
- All pivot point are bushed with grease nipples and all pivot point locked in rotation.
Easy to set in Transport / Working position :
- No need to dismantle the top link when going to transport position.
- Hydraulic lock/unlock in transport position from tractor cab.
- Easy manouevre of the Dual lateral Wheel boggie.
Why an hydraulic angle adjsutment on headstock ?
- Higher performances when ploughing on hilly ground or in the slope.
- Better opening of the ground and easier marques of the side ploughing.
- easier and safer hitch / uncoupling through horizontal position of the headstock.
- Full safety of the system through anti-return valve on the turnover ram.
Why choosing an hydraulic working width adjustment ?
- Adapting working width to all types of soil and tractor HP.
- Ajustment of the last furrow to plough at the end of the field.
- Instant Correction of a badly done furrow or improved ploughing in the slope.
Advantages of Dual Wheel Boggie :
- Wheel does not go over the frame, last furrow takes wheel mark out (Except with 5 furrows).
- Depth control through turnbuckle.
- Shock absorber for transport
- Improved performance on wet conditions as the weight is balanced between the 2 wheels on the boggie.
Bar point 35 x 35 or shares + reversible point
STANDARD EQUIPMENTS :
HEADSTOCK : - Fixed coupling Cat III in yoke, with pins (Lower and Top link) locked against rotation.
- headstock RHAD 150.
- Ø 150 mm shaft, with 2 bearings from the same diameter.
- Hydraulic shock absorber for manouevre at the end of the field.
- Hydraulic adjustment "on the move" of the working angle.
- hydraulic Lock/Unlock in transport position from tractor cab.
FRAME : - Frame section 180 x 180 mm.
- Hydraulic 1st furrow adjustment (Width of the 1st furrow).
- Hydraulic vari width adjustment 12" à 20", and hydraulic compensation kit with rubber shock absorber.
- Memory ram on working width, allows automatic return in working position after turnover.
FURROWS : - Furrow with offset legs to ensure better balance of efforts on all pivot points and ball joints.
BODIES : - 16",with adjustment of share zorking angle (For dr y or compressed soil).
- .
- Knife coulters.
- Mouldboards : Helicoïdal short (N° 4, N°5), Flat cylindrical (P14, P16), cylindrical (C14, C16) or American (3A, 5A).
SKIMMERS : - Shearbolt safety device.
- Manure, mixed or trashboards.
DUAL WHEELS : - Dual lateral wheel boggie for depth in work & transport with rubber shock absorber
LATERAL BOGIE
- 2 wheels are used in transport (Carriage type) and at work (boggie configuration ).
- 2 tyres 11.0/65 x 12, Tractor Profil Ø : 700 mm width : 290 mm
- Hydrqulic adjustment of wheel as option
Click here to view video. |
